Not sure who's at flaut here. It seems like it works really good but if I print tall parts the bottom starts warping/shrinking before the top is done printing and changes the print surface which then slowly ruins the part. I have tried a million different build plate temps, extruder temps etc. can't seem to get a really good part, could be me, the part, the part orientation. my printer, and a million other reasons so I can't for sure point the finger that the filament but thought to mention, if anyone else is having these same problems and NOT using an Ultimaker like me it could show material instability. So I give it a 4 because the price is fair and its a lot of material. I also like the big roles.

This is my holy grail product for my 3a/b (Botticelli) hair. I use it mixed with Biosilk Rock Hard Gelee (about 3/4 KCCC, 1/4 BRHG) and it gives me perfect, bouncy curls. I want the hard cast because I'm looking for firm hold, but it scrunches out beautifully. I use about two quarter's worth for my hair, which is very thick and slightly above bra strap length when wet. Sometimes I use it over Kinky Curly Knot Today, but not always, and I haven't had any trouble using it over other products. For next day hair, I usually just smooth/scrunch a bit of water, then a couple of drops of camellia oil, or sometimes a little Shea Moisture Coconut & Hibiscus Milk mixed with a drop or two of oil. Perfect.

Perfect fit for our 2014 Ford Explorer. Much nicer look than the factory one. No tools required to install. Well worth it.